Efficient tri-wavelength actively Q-switched Yb:GAGG laser

An efficient acousto-optic Q-switched Yb-doped Gd₃Al_xGa_5−xO₁₂ (GAGG) (x = 0.5) laser is demonstrated. Under the absorbed pump power of 7.4 W, the maximum average output power of 1.4 W is obtained at the pulse repletion rate of 1 kHz , with the slope efficiency as high as 32%. The pulse width of 40 ns is achieved with the pulse energy and peak power of 1.4 mJ and 35 kW, respectively. What’ more, the output spectrum shows itself tri-wavelength in either CW or Q-switching mode. To our knowledge, this is the first time for realizing simultaneous tri-wavelength Yb:GAGG laser actively Q-switched operation.     

Automated network management and configuration using Probabilistic Trans-Algorithmic Search

Online configuration of large-scale systems such as networks requires parameter optimization within a limited amount of time, especially when configuration is needed as a response to recover from a failure in the system. To quickly configure such systems in an online manner, we propose a Probabilistic Trans-Algorithmic Search (PTAS) framework which leverages multiple optimization search algorithms in an iterative manner. PTAS applies a search algorithm to determine how to best distribute available experiment budget among multiple optimization search algorithms. It allocates an experiment budget to each available search algorithm and observes its performance on the system-at-hand. PTAS then probabilistically reallocates the experiment budget for the next round proportional to each algorithm’s performance relative to the rest of the algorithms. This “roulette wheel” approach probabilistically favors the more successful algorithm in the next round. Following each round, the PTAS framework “transfers” the best result(s) among the individual algorithms, making our framework a trans-algorithmic one. PTAS thus aims to systematize how to “search for the best search” and hybridize a set of search algorithms to attain a better search. We use three individual search algorithms, i.e., Recursive Random Search (RRS) (Ye and Kalyanaraman, 2004), Simulated Annealing (SA) (Laarhoven and Aarts, 1987), and Genetic Algorithm (GA) (Goldberg, 1989), and compare PTAS against the performance of RRS, GA, and SA. We show the performance of PTAS on well-known benchmark objective functions including scenarios where the objective function changes in the middle of the optimization process. To illustrate applicability of our framework to automated network management, we apply PTAS on the problem of optimizing link weights of an intra-domain routing protocol on three different topologies obtained from the Rocketfuel dataset. We also apply PTAS on the problem of optimizing aggregate throughput of a wireless ad hoc network by tuning datarates of traffic sources. Our experiments show that PTAS successfully picks the best performing algorithm, RRS or GA, and allocates the time wisely. Further, our results show that PTAS’ performance is not transient and steadily improves as more time is available for search.     

MG410采煤机滚筒辅助叶片板的增设与应用

针对MG170/410-WD滚筒式采煤机在大倾角、仰角、“三软”煤层使用中遗漏在机道中的浮煤多、装煤效率低等问题,通过添加螺旋板数量对采煤机滚筒进行改造。改造后,在滚筒转速不变的情况下,提高抛煤效率,缩短了工作面割煤和工作面空顶时间,提高了装煤效率,从源头上降低了顶板管理的安全风险。     

A two stage heuristic algorithm for the integrated aircraft and crew schedule recovery problems

Airline disruptions incurred huge cost for airlines and serious inconvenience for travelers. In this paper, we study the integrated aircraft and crew schedule recovery problem. A two stage heuristic algorithm for the integrated recovery problem is proposed. In the first stage, the integrated aircraft recovery and flight-rescheduling model with partial crew consideration is built. This model is based on the traditional multi-commodity network model for the aircraft schedule recovery problem. The objective of this model also includes minimization of the original crew connection disruption. In the second stage, the integrated crew schedule recovery and flight re-scheduling model with partial aircraft consideration is built. We proposed a new multi-commodity model for the crew schedule recovery. The main advantage of such model is that it is much more efficient to integrate the flight-scheduling and aircraft consideration. New constraints are incorporated to guarantee that the aircraft connections generated in the stage 1 are still feasible. Two stages are run iteratively until no improvement can be achieved. Experimental results show that our method can provide better recovery solutions compared with the benchmark algorithms.     

Electrochemical growth and characterization of iron doped cadmium sulfide thin films

Cadmium Sulfide and Ferrous doped Cadmium Sulfide thin films have been prepared on different substrates using an electrodeposition technique. Linear sweep voltammetric analysis has been carried out to determine deposition potential of the prepared films. X-ray diffraction analysis showed that the prepared films possess polycrystalline nature with hexagonal structure. Surface morphology and film composition have been analyzed using Scanning electron microscopy and Energy dispersive analysis by X-rays. Optical absorption analysis showed that the prepared films are found to exhibit Band gap value in the range between 2.3, 2.8 eV for Cadmium Sulfide and Ferrous doped Cadmium Sulfide.     

Characterizing physical habitat preferences and thermal refuge occupancy of brook trout (Salvelinus fontinalis) and Atlantic salmon (Salmo salar) at high river temperatures

Anthropogenic influences, including climate change, are increasing river temperatures in northern and temperate regions and threatening the thermal habitats of native salmonids. When river temperatures exceed the tolerance levels of brook trout and Atlantic salmon, individuals exhibit behavioural thermoregulation by seeking out cold‐water refugia – often created by tributaries and groundwater discharge. Thermal infrared (TIR) imagery was used to map cold‐water anomalies along a 53 km reach of the Cains River, New Brunswick. Trout and salmon parr did not use all identified thermal anomalies as refugia during higher river temperature periods (>21°C). Most small‐bodied trout (8–30 cm) were observed in 80% of the thermal anomalies sampled. Large‐bodied trout (>35 cm) required a more specific set of physical habitat conditions for suitable refugia, that is, 100% of observed large trout used 30% of the anomalies sampled and required water depths >65 cm within or adjacent to the anomaly. Densities of trout were significantly higher within anomalies compared with areas of ambient river temperature. Salmon parr were less aligned with thermal anomalies at the observed temperatures, that is, 59% were found in 65% of the sampled anomalies; and densities were not significantly different within/ outside anomalies. Salmon parr appeared to aggregate at 27°C, and after several events over 27°C variability in aggregation behaviour was observed – some fish aggregated at 25°C, others did not. We stipulate this is due to variances of thermal fatigue. Habitat suitability curves were developed for velocity, temperature, depth, substrate, and deep water availability to characterize conditions preferred by fish during high‐temperature events. These findings are useful for managers as our climate warms, and can potentially be used as a tool to help conserve and enhance thermal refugia for brook trout and Atlantic salmon in similar systems.     

Calorimetric study of ytterbium orthovanadate YbVO4 polycrystalline ceramics

The heat capacity of ytterbium orthovanadate was first measured by adiabatic calorimetry in the temperature range T?=?12.28–344.06?K. No obvious anomalies were observed on the curve obtained. The values of standard thermodynamic functions in the temperature range T?=?0–400 K were calculated. Based on low-temperature calorimetry data obtained, previously published data on the high-temperature heat capacity of ytterbium orthovanadate were corrected. The anomalous contribution to heat capacity for YbVO₄ was compared with the data known for YbPO₄.     

Evaluation of expanded gamut software solutions for spot color reproduction

Expanded gamut printing is an approach in color reproduction that expands the color gamut of conventional CMYK printing processes via the use of additional colorants, such as Orange, Green, and Violet inks. This study evaluates the ability of commercial color management software to create an accurate solution for an expanded gamut printing system. In this study, two printing processes were used, an Epson SureColor P9000 inkjet printer/proofer and an HP Indigo 7900 digital production press, both with 7-color expanded gamut ink sets. Software solutions from Alwan, CGS ORIS, ColorLogic, GMG Color, Heidelberg, and Kodak were evaluated. The systems were tested to see how well they could reproduce the colors in the entire PANTONE+ Solid Coated spot color library. It is shown that the solutions are able to reproduce 89% to 94% of the spot colors on the Epson P9000 inkjet printer and 77% to 87% of the library on the Indigo 7900, both to less than two CIEDE2000 (a typical tolerance in label and packaging work). The number of color patches in expanded gamut characterization test charts was noted, as this is still an area of proprietary, nonstandardized working practice. There are many different colorant combinations that can make the same color in expanded gamut printing. The ink build created by the different software solutions was studied, as it relates to press stability through appropriate choice of colorants. Pantone and Adobe provide everyday commercial tools for expanded color workflows. The study identified some issues with products from these companies that could confuse a less-skilled user in a busy production environment. The conclusion of the study is that expanded gamut solutions for spot color printing produce totally acceptable results for digital printing processes; expanded gamut printing is ready, here and now. The findings show that expanded gamut printing can replace cumbersome conventional spot color workflows creating considerable savings and advantages, especially for label and packaging printers.     

A grounded theory examination of project managers' accountability

26 interviews were conducted with a snowball sample of project managers to explore how project managers were influenced by accountability arrangements and how they responded to accountability demands. Using a grounded theory approach to code the interview data, this study revealed that project managers develop new skills to respond to accountability demands. These effects are facilitated by the interaction of resource-based mechanisms and reflexivity that interact with the contextual factors of the project. The study broadens the understanding of accountability in project management and suggests a model for further empirical examination.     

Iron mediated cathodic electrosynthesis of hausmannite nanoparticles

A novel synthetic route has been proposed to prepare hausmannite nanoparticles. The synthetic route comprises an iron mediated constant current cathodic electrodeposition of manganite and heat treatment of the latter to obtain hausmannite. The obtained nanostructures have been characterized using X-ray Diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectrometry (EDX) and Fourier transform Infrared Spectrometry (FTIR). The role of iron in the formation of manganite precursor has been studied by cyclic voltammetry (CV) and differential thermal analysis (DTA). A formation mechanism based on iron mediated formation of Mn³⁺ and subsequent cathodic reduction of the disproportionated products has been proposed accordingly. The prepared nanoparticles exhibited specific capacitance of 143 F g⁻¹ in 0.5 M Na₂SO₄ solution. The retained specific capacity was 87% after 2000 cycles.